Journal of Electrical Engineering and Automation
IRO Journals
Volume 5 — Issue 1 — March 2023

A HYBRID MPPT ALGORITHM FOR SOLAR PV WITH BATTERY CONNECTED SYSTEM

https://doi.org/10.36548/jeea.2023.1.004
Harrini R
Power Systems Engineering, Government College of Technology, Coimbatore, India
V. Gopalakrishnan
Electrical & Electronics Engineering, Government College of Technology, Coimbatore, India
PDF
PDF

How to Cite

R, Harrini, and V. Gopalakrishnan. 2023. “A HYBRID MPPT ALGORITHM FOR SOLAR PV WITH BATTERY CONNECTED SYSTEM”. Journal of Electrical Engineering and Automation 5 (1): 46-65. https://doi.org/10.36548/jeea.2023.1.004.
ACM ACS APA ABNT Chicago Harvard IEEE MLA Turabian Vancouver AMA

Download Citation

Endnote/Zotero/Mendeley (RIS) BibTeX

Keywords

— Photovoltaic
— MPPT
— Artificial Neural Network Perturb and Observe
— Single DC-DC converter
Published: 26-04-2023

Abstract

Electricity generation using renewable energy resources rather than fossil fuels reduces gobar gas emissions from the power sector and prevents pollution. The best alternative to conventional energy sources is solar photovoltaic (PV) generation; however, it has some significant disadvantages, including high initial costs, poor photoconversion efficiency, and climatic dependencies. In order to overcome this, PPT techniques are used. The projected work provides a solar power system which tracks the maximum power point using Artificial Neural Network and Perturb and Observe algorithm. Additionally, it adds a new setup for the system that links the photovoltaic array as well as the battery to the system inverter’s DC-link through a single DC-DC converter that can act as both charge controller and Maximum Power Point Tracking (MPPT) device at the same time. When solar energy production exceeds demand, the excess energy is stored in batteries and provided during periods of very low irradiance. The DC voltage is converted into AC voltage using an inverter. The benefit of this technique is that it has greater tracking accuracy. For validation, the proposed model has been analyzed by using MATLAB/Simulink.

References

  1. Wei Zhang, Guopeng Zhou , Haoni , and Yunlia sun, 2019, “A Modified Hybrid Maximum Power Point Tracking Method for Photovoltaic Arrays Under Partially Shading Condition”, Journal Article, IEEE access ,volume 4, pp. 181-188
  2. T. Esram, P.L. Chapman, "Comparison of photovoltaic array maximum power point tracking techniques," IEEE Transactions on Energy Conversion, vol. 22, no. 2, pp. 439-449, 2007.
  3. K. Ishaque , Z. Salam, "A review of maximum power point tracking techniques of PV system for uniform insolation and partial shading condition," Renewable and Sustainable Energy Reviews, vol. 19, pp. 475-488, 2013.
  4. L.L. Buciarelli, B.L. Grossman, E.F. Lyon, N.E. Rasmussen, "The energy balance associated with the use of a MPPT in a 100 kW peak power system," IEEE Photovoltaic Specialists Conference, pp. 523-527, 1980.
  5. K.H. Hussein, I. Muta, T. Hoshino, Osakada M, "Maximum photovoltaic power tracking: an algorithm for rapidly changing atmospheric conditions," IEE Proceedings of Generation, Transmission and Distribution, vol. 142, no. 1, pp. 1350-2360, 1995.
  6. H. Patel, V. Agarwal, "Maximum power point tracking scheme for PV systems operating under partially shaded conditions," IEEE Transactions on Industrial Electronics, vol. 55, no. 4, pp. 1689-1698, 2008.
  7. Y.H. Ji, D.Y. Jung, J.G. Kim et al, "A real maximum power point tracking method for mismatching compensation in PV array under partially shaded conditions," IEEE Transactions on Power Electronics, vol. 26, no. 4, pp. 1001-1009, 2010.
  8. K. Kobayashi, I. Takano, Y. Sawada, "A study of a two stage maximum power point tracking control of a photovoltaic system under partially shaded insolation conditions," Solar Energy Materials and Solar Cells, vol. 90, no. 18-19, pp. 2975-2988, 2006.
  9. N. Kumar, H. Ikhlaq, B. Singh, and B. K. Panigrahi, May 2017, "Rapid MPPT for uniformly and partial shaded PV system by using JayaDE algorithm in highly fluctuating atmospheric conditions," IEEE Trans. on Ind. Informatics., vol. 13, no. 5 pp. 2406- 2416.
  10. S. Chandel, M. N. Naik, and R. Chandel, May 2015,“Review of solar photovoltaic water pumping system technology for irrigation and community drinking water supplies,” in Renewable and Sustainable Energy Reviews, Vol.49, no.9,pp.1084-1099.
  11. “Solar PV array fed water pumping system using SEPIC converter based BLDC motor drive,” in Proc. Eighteenth National Power Systems Conf., Guwahati, Dec 2014, pp. 1–5.
  12. “Buck-boost converter fed BLDC motor drive for solar PV array based water pumping,” in Proc. IEEE Power Electronics, Drives and Energy Systems International Conf., Mumbai, Dec 2014, pp. 1–6.
  13. G. N. A. Maranho, A. U. Brito, J. T. Pinho, J. K. S. Fonseca, A. M. Leal, and W. N. Macłdo, “Experimental results of a fuzzy controlled variable speed drive for photovoltaic pumping systems: A review,” IEEE Sensors J., vol. 16, no. 9, pp. 2854–2864, May 2016.
  14. S. A. K. M. Niapoor, S. Danyali, and M. B. B. Sharifian, “PV power system based MPPT Z-source inverter to supply a sensorless BLDC motor,” in Proc. 1st Power Electronic Drive Systems Technologies Conf., Tehran, Feb 2010, pp. 111–116.
  15. S. Jain, A. K. Thopukara, R. Karampuri, and V. T. Somasekhar, “A single-stage photovoltaic system for a dual-inverter-fed open-end winding induction motor drive for pumping applications,” IEEE Trans. Power Electron., vol. 30, no. 9, pp. 4809–4818, Sept 2015.
  16. S. Jain, R. Karampuri, and V. T. Somasekhar, “An integrated control algorithm for a single-stage pv pumping system using an open-end winding induction motor,” IEEE Trans. Ind. Electron., vol. 63, no. 2, pp. 956–965, Feb 2016.
  17. S. Sashidhar and B. G. Fernandes, “A novel ferrite SMDS spoke-type BLDC motor for PV bore-well submersible water pumps,” IEEE Trans. Ind. Electron., vol. 64, no. 1, pp. 104–114, Jan 2017
  18. P. Damodharan and K. Vasudevan, “Sensorless brushless DC motor drive based on the zero-crossing detection of back electromotive force (EMF) from the line voltage difference,” IEEE Trans. Energy Convers., vol. 25, no. 3, pp. 661–668, Sept 2010.
  19. P. Damodharan, R. Sandeep, and K. Vasudevan, “Simple position sensorless starting method for brushless DC motor,” IET Electr. Power Appl., vol. 2, no. 1, pp. 49–55, Jan 2008.
  20. K. H. Ahmed, M. S. Hamad, S. J. Finney, and B. W. Williams, “DC-side shunt active power filter for line commutated rectifiers to mitigate the output voltage harmonics,” in Proc. IEEE Energy Conversion Congress and Exposition International Conf., Atlanta, Sept 2010, pp. 151–157.
  21. R. Kumar and B. Singh, “BLDC motor-driven solar PV array-fed water pumping system employing zeta converter,” IEEE Trans. Ind. Appl., vol. 52, no. 3, pp. 2315–2322, May 2016.
  22. P. Bhatnagar, R.K. Nema, "Maximum power point tracking control techniques: State-of-the-art in photovoltaic applications," Renewable and Sustainable Energy Reviews, vol. 23, pp. 224-241, 2013.