Industrial Quality Prediction System through Data Mining Algorithm
Volume-3 | Issue-2
Comparative Analysis an Early Fault Diagnosis Approaches in Rotating Machinery by Convolution Neural Network
Volume-3 | Issue-2
Nakagami-m Fading Detection with Eigen Value Spectrum Algorithms
Volume-3 | Issue-2
Abstractive Summarization System
Volume-3 | Issue-4
Design of Adaptive Estimator for Nonlinear control system in Noisy Domain
Volume-3 | Issue-3
Automated Nanopackaging using Cellulose Fibers Composition with Feasibility in SEM Environment
Volume-3 | Issue-2
Comparative Analysis of Temperature Measurement Methods based on Degree of Agreement
Volume-3 | Issue-3
Transistor Sizing using Hybrid Reinforcement Learning and Graph Convolution Neural Network Algorithm
Volume-3 | Issue-3
A Review on Meshing Techniques in Biomedicine
Volume-3 | Issue-4
EL DAPP - An Electricity Meter Tracking Decentralized Application
Volume-2 | Issue-1
SMART STREET SYSTEM WITH IOT BASED STREET LIGHT OPERATION AND PARKING APPLICATION
Volume-1 | Issue-1
ENERGY AND POWER EFFICIENT SYSTEM ON CHIP WITH NANOSHEET FET
Volume-1 | Issue-1
Abstractive Summarization System
Volume-3 | Issue-4
A Review on Meshing Techniques in Biomedicine
Volume-3 | Issue-4
MIMO BASED HIGH SPEED OPTICAL FIBER COMMUNICATION SYSTEM
Volume-1 | Issue-2
Industrial Quality Prediction System through Data Mining Algorithm
Volume-3 | Issue-2
Comparative Analysis of Temperature Measurement Methods based on Degree of Agreement
Volume-3 | Issue-3
Transistor Sizing using Hybrid Reinforcement Learning and Graph Convolution Neural Network Algorithm
Volume-3 | Issue-3
VIRTUAL REALITY SIMULATION AS THERAPY FOR POSTTRAUMATIC STRESS DISORDER (PTSD)
Volume-1 | Issue-1
Comparative Analysis an Early Fault Diagnosis Approaches in Rotating Machinery by Convolution Neural Network
Volume-3 | Issue-2
Volume - 5 | Issue - 4 | december 2023
Published
24 January, 2024
A high-gain metamaterial-enabled circularly polarized antenna has been proposed. Two patch structures patch A and patch B have been designed by using different shape slots. After slot etching on the patch, two different metamaterial techniques were used. Circular metamaterial (MTM) was implemented for Patch A, while rectangular MTM was used for Patch B. The implementation of MTM resulted in increased antenna gain, as well as improvements in impedance bandwidth RL and AR. So, in the proposed article two antenna structures ANT-A and ANT-B, are presented. The maximum gain achieved for ANT-A is 34.759dBi, covering the frequency bands (28.997-202.113) GHz, and (205.884-336.693) while in the case of ANT-B, it is 36.3155dBi, covering the frequency bands (29.178-330.490) GHz, and (334.936-336.702) GHz. The proposed antenna structure is a useful design for mm-wave 5G and 6G Sub-THz communications.
KeywordsCP AR MTM Sub-THz mm-Wave
Full Article PDF