Abstract
This research article focuses on industrial applications to demonstrate the characterization of current and vibration analysis to diagnose the induction motor drive problems. Generally, the induction motor faults are detected by monitoring the current and proposed fine-tuned vibration frequency method. The stator short circuit fault, broken rotor bar fault, air gap eccentricity, and bearing fault are the common faults that occur in an induction motor. The detection process of the proposed method is based on sidebands around the supply frequency in the stator current signal and vibration. Moreover, it is very challenging to diagnose the problem that occur due to the complex electromagnetic and mechanical characteristics of an induction motor with vibration measures. The design of an accurate model to measure vibration and stator current is analyzed in this research article. The proposed method is showing how efficiently the root cause of the problem can be diagnosed by using the combination of current and vibration monitoring method. The proposed model is developed for induction motor and its circuit environment in MATLAB is verified to perform an accurate detection and diagnosis of motor fault parameters. All stator faults are turned to turn fault; further, the rotor-broken bar and eccentricity are structured in each test. The output response (torque and stator current) is simulated by using a modified winding procedure (MWP) approach by tuning the winding geometrical parameter. The proposed model in MATLAB Simulink environment is highly symmetrical, which can easily detect the signal component in fault frequencies that occur due to a slight variation and improper motor installation. Finally, this research article compares the other existing methods with proposed method.
References
Refaat, S.S., Abu-Rub, H., Saad, M.S., Aboul-Zahab, E.M., Iqbal, A., "Detection, diagnoses and discrimination of stator turn-to-turn fault and unbalanced supply voltage fault for three-phase induction motors," Power and Energy (PECon), 2012 IEEE International Conference on 2-5 Dec. 2012, pp.910-915.
Mehala, Neelam, and Ratna Dahiya. "Motor current signature analysis and its applications in induction motor fault diagnosis." International journal of systems applications, engineering & development vol.2, no. 1, pp.29-35, 2007.
Dash, Sourabh, and Venkat Venkatasubramanian. "Challenges in the industrial applications of fault diagnostic systems." Computers & Chemical Engineering, 24.2 (2000): pp. 785-791.
M. Kathiravan and K. Prakasam, "Motor current signature analysis based Fault diagnosis of induction motor", International Journal of Power Control and Computation(IJPCSC), vol. 6, no. 2, pp. 56-62, Jan-March 2014.
Ielyzaveta Chernyavskal and OndĜej Vítek, "Analysis of Broken Rotor Bar Fault in a SquirrelCage Induction Motor by Means of Stator Current and Stray Flux Measurement", International Power Electronics and Motion Control Conference, 24 November 2016.
T. C H. Anil, Kumar, Gurmeet Singh and V. N. A. Naikan, "Effectiveness of Vibration and Current Monitoring in detecting Broken Rotor Bar and Bearing Faults in an Induction Motor", International Conference on Power Systems, 06 October 2016.
A Singhal and M A. Khandekar, "Bearing Fault Detection in Induction Motor Using Motor Current Signature Analysis", International Journal of Advanced Research in Electrical Electronics and Instrumentation Engineering, vol. 2, no. 7, pp. 3258-3264, July 2013.
Matta Suresh and K.C. Deekshit Kompella, "Diagnosis of Induction Motor Stator Faults by using Motor Current Signature Analysis Method", IJCT A, vol. 10, no. 5, pp. 541-550, 2017.
Ielyzaveta Ishkova and Ondřej Vítek, "Diagnosis of eccentricity and broken rotor bar related faults of induction motor by means of motor current signature analysis", International Scientific Conference on Electric Power Engineering, 2015.
Pravin P. Joshi and M.R. Bachwad, "Condition Monitoring of Induction Motor with A Case Study", International Journal of Electrical Engineering & Technology (IJEET), vol. 6, no. 6, pp. 10-15, June 2015.
Kato, T., Inoue, K., Yoshida, K., Itokawa, T., "Diagnosis of multi-turn faults of induction motor by direct detection of asymmetry admittance component," Power Electronics and Drive Systems (PEDS), 2013 IEEE 10th International Conference on 22-25 April 2013, pp.778-783.
Trabelsi, M., M. Boussak, P. Mestre, and M. Gossa. "Pole voltage based approach for IGBTs open circuit fault detection and diagnosis in PWM-VSI-Fed induction motor drives." In Power Engineering, Energy and Electrical Drives (POWERENG), 2011 International Conference on, pp. 1-6. IEEE, 2011.
Aktas, M., Turkmenoglu, V., "Wavelet-based switching faults detection in direct torque control induction motor drives," Science, Measurement & Technology, IET vol.4, no.6, pp.303-310, November 2010.
Das, S., Purkait, P., Chakravorti, S., "Separating Induction Motor Current Signature for stator winding faults from that due to supply voltage unbalances," Power and Energy in NERIST (ICPEN), 2012 1st International Conference on, vol., no., pp. 1-6, 28-29 Dec. 2012.
Khan, M., Rahman, M.A., "Discrete Wavelet Transform Based Detection of Disturbances in Induction Motors," Electrical and Computer Engineering, 2006; International Conference on 19-21 Dec. 2006, pp.462-465.
Soualhi, Abdenour, Guy Clerc, and Hubert Razik. "Detection and diagnosis of faults in induction motor using an improved artificial ant clustering technique."Industrial Electronics, IEEE Transactions on 60, no. 9 (2013): 4053-4062.
Amaral, T.G., Pires, V.Fernao, Martins, J.F., Pires, A.J., Crisostomo, Manuel M., "Statistic Moment Based Method for the Detection and Diagnosis of Induction Motor Stator Fault," Power Engineering, Energy and Electrical Drives, 2007. POWERENG 2007. International Conference on, 12-14 April 2007, pp.106-110.
Eltabach, M., Charara, A., Antoni, J., "Comparative investigation of non-invasive diagnosis methods for mechanical fault detection in induction motors," Industrial Electronics, 2004 IEEE International Symposium on, 4-7 May 2004, vol.1, pp.365-370.
Chetwani, S. H., M. K. Shah, and M. Ramamoorty. "On-line condition monitoring of induction motors through signal processing." In Electrical Machines and Systems, 2005. ICEMS 2005. Proceedings of the Eighth International Conference on, vol. 3, pp. 2175-2179. IEEE, 2005.
Sousa, K.M.; Dreyer, U.J.; Martelli, C.; Da Silva, J.C.C. Dynamic Eccentricity Induced in Induction Motor Detected by Optical Fiber Bragg Grating Strain Sensors. IEEE Sens. J. 2016, 16, 4786–4792.[CrossRef]
Kang, T.-J.; Kim, J.; Bin Lee, S.; Yung, C. Experimental Evaluation of Low-Voltage Offline Testing for Induction Motor Rotor Fault Diagnostics. IEEE Trans. Ind. Appl. 2015, 51, 1375–1384.[CrossRef]
Godoy, W.F.; Da Silva, I.N.; Lopes, T.D.; Goedtel, A.; Palácios, R.H.C. Application of intelligent tools to detect and classify broken rotor bars in three-phase induction motors fed by an inverter. IET Electr. Appl. 2016, 10, 430–439.[CrossRef]
Frosini, L.; Harlisca, C.; Szabó, L. Induction Machine Bearing Fault Detection by Means of Statistical Processing of the Stray Flux Measurement. IEEE Trans. Ind. Electron. 2015, 62, 1846–1854.[CrossRef]
Faiz, J.; Nejadi-Koti, H.; Valipour, Z. Comprehensive review on inter-turn fault indexes in permanent magnet motors. IET Electr. Appl. 2017, 11, 142–156.[CrossRef]
Abdallah, H.; Benatman, K. Stator winding inter-turn short-circuit detection in induction motors by parameter identification. IET Electr. Appl. 2017, 11, 272–288.[CrossRef]
Ghanbari, T. Autocorrelation function-based technique for stator turn-fault detection of induction motor. IET Sci. Meas. Technol. 2016, 10, 100–110.[CrossRef]
Maitre, J.; Bouchard, B.; Bouzouane, A.; Gaboury, S. Classification Algorithms Comparison for Interturn Short-Circuit Recognition in Induction Machines Using Best-Fit 3-D-Ellipse Method. Can. J. Electr. Comput. Eng. 2017, 40, 255–265.
Hou, Z.; Huang, J.; Liu, H.; Ye, M.; Liu, Z.; Yang, J. Diagnosis of broken rotor bar fault in open- and closed-loop controlled wye-connected induction motors using zero-sequence voltage. IET Electr. Power Appl. 2017, 11, 1214–1223.[CrossRef]
Boudinar, A.H.; Benouzza, N.; Bendiabdellah, A. Induction Motor Bearing Fault Analysis Using a Root-MUSIC Method. IEEE Trans. Ind. Appl. 2016, 52, 3851–3860.[CrossRef]
Antonino-Daviu, J.A.; Arkkio, A.; Georgoulas, G.; Climente-Alarcon, V.; Tsoumas, I.P.; Stylios, C.D.; Nikolakopoulos, G. The Use of a Multilabel Classification Framework for the Detection of Broken Bars and Mixed Eccentricity Faults Based on the Start-Up Transient. IEEE Trans. Ind. Inform. 2017, 13, 625–634.